Table of Contents
Advertisement
Remote Control Auto-Find
If Programming the Remote did not find your product's code, try this procedure, to
automatically find the code for your device. If your remote becomes inoperable, go back to
"Programming your Remote" and enter the Zenith TV code for step five
1
Turn on the device you're programming into a
remote control mode.
2
Press and hold the PRG key until the indicator light
turns on.
3
Press the key for the device you're trying to program
(CABLE, VCR, AUX, TV).
4
Enter the code 0-0-0 (zero-zero-zero), then press the
ENTER key right away.
5
Point the remote at the product and press POWER.
Allow a second to pass, then push the POWER key
again. Repeat until the device turns off. (This is a
trial and error process. It may be necessary to repeat
the above steps until the remote finds a code that
will operate the product.)
6
Push ENTER to save the code.
7
Press POWER to turn the device back on.
You can quickly get out of Auto Find by pressing QUIT.
If the indicator light stays on while you push Power, instead
of turning off, all the codes have been tried and the device
can't be programmed.
206-3689-A
2
PRG
Indicator Light
CABLE
VCR
FLASHBK
SURF
CHANNEL
VOLUME
CHANNEL
1
4
7
4
0
MENU
RECORD
PAUSE
PLAY
REWIND
STOP
5/7
POWER
AUX
TV
MUTE
VOLUME
2
3
5
6
8
9
ENTER
QUIT
TV/VCR
TIMER
SOURCE
FFWD
P A G E 3 7
3
6
Advertisement
Table of Contents
