Operation Notes - Zenith HealthView H20E50DT Installation And Operating Manual, Warranty

Clone Selection Menu Choices

Operation Notes

Disconnect the Clone from the TV when you are finished; auto-
matically switching it off. The real-time clock continues to run
when the main circuits are switched off.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the programmer
behaves strangely after a static shock, use a paper clip or similar
instrument inserted through the small hole marked "RESET" to
activate the internal reset switch and restore normal operation.
After a reset, check the real-time clock setting. It may be neces-
sary to reset the Clone Programmer clock from a TV containing
the correct time.
Troubleshooting
Problem
Clone Programmer
LED does not blink.
Clone menu hard
to read.
No time set.
Menu items 7-8 not
on clone selection menu.
Master and Other TVs
Cloning did not work.
Clone time disappeared.
Channel Labels not
present on cloned TV.
New Setup not present.
When cloning operations are complete, just unplug the LT2000 from the TV.
If the TV does not display a picture (blank screen) after a few seconds, just change channels.
NOAUX3684
Possible Cause(s)
• MPI cord not connected.
• TV not turned on.
• Weak batteries.
• Weak signal.
• No time on Master TV.
• Not necessary.
• Procedure interrupted.
• Different TV models.
• Batteries were removed.
• Saved to other memory.
• TV not reset.
The LT2000 programmer is designed to be used with TVs contain-
ing the 221-01006 and later processors. Use with earlier TV sets
may give unpredictable results. The specific microprocessor used
in any TV set may be determined by activating the Installer
Menu. The microprocessor part number appears at the top of the
screen when the Installer Menu is activated. Processors before
the 221-01006-04 have a limited screen display capability. They
can not display entire screens as shown in the quick setup
instructions accompanying the LT2000 clone programmer. Use the
printed menu illustrations on the quick setup sheet supplied with
the Clone as an aid to making your programming choices.
(Although the menus are not all displayed, the clone functions
all operate normally.)
Possible Solution(s)
-Connect MPI cord.
-TV must be on for clone to work.
-Install 4 fresh AA high-quality alkaline batteries.
-Connect TV to a reliable signal source.
-Set time on master TV, copy time to Clone Programmer.
-Channel Labels already cloned; if they were on Master TV.
-Wait until procedure complete message is displayed.
-Cloning is only possible with identical model TVs.
-Batteries must remain installed to retain time settings.
-Must save channel labels to same memory bank as
master TV setup.
-Disconnect newly cloned TV from power for 5 seconds.
P A G E 3 5