Auto Program (Channel Search)
Use Auto Program to specify Cable TV or Off Air Antenna
incoming signal source and automatically store in the mem-
ory of the TV, all of the channels that are found by the
channel search
1
With the optional Installer remote control in hand, press
the POWER key to turn on the HealthView TV.
2
Press the MENU key to show the Setup menu.
3
Using SELECT on the remote control, highlight Auto
Program on the screen.
4
Press the Right or Left ADJ (Adjust) arrow to go to the
Auto Program menu.
5
Using SELECT, choose either Cable TV or Off Air Antenna
on the screen.
6
Press the Right or Left ADJ arrow to begin the Channel
Search.
7
Press ENTER when the channel search is complete.
Auto Program finds channels being received by the TV tuner.
Cable will not work unless the hospital provides a cable service.
Optional Installer and Patient Remote Controls:
Shown herein are optional remote controls that can be used by the
installer and the patient. Be advise that these remote controls are
NOT included with this TV. However, these remotes can be purchased
separately, see your Zenith dealer.
Mini glossary
OFF AIR ANTENNA
If the patient can only view over-the-air broadcasts, select Antenna.
CABLE
If you provide cable service to the patients, select Cable.
206-3747
AUTO PROGRAM
ADD/DEL/BLNK
CH. LABELS
CLOCK SET
TIMER
CAPTIONS
LANGUAGE
POWER
1
1
2
4
5
7
8
0
BED 1
TIMER
MENU
SELECT
3/5
ADJ
4/6
3
6
9
ENTER
7
BED 2
2
BANK
CH PREVIEW
ADJ
P A G E 1 1