Pip/Pop/Split - Zenith D60WLCD Installation And Operating Manual, Warranty

PIP/POP/SPLIT

Press the PIP button on the remote con-
1
trol in PIP mode to activate POP (Picture
out of Picture) mode.
Press the EXIT button to exit POP mode
2
or press the PIP button again to activate
Split mode.
Press the LEFT/RIGHT arrow in Split
3
mode to select CH+/-, Swap or Source.
• CH+/- : Press the UP/DOWN arrow to
select a program of sub picture.
To change programs of sub picture is
possible only when PIP signal source
is NTSC RF signal.
If you want to change a program of
main picture, press pg up/dn button.
• Swap : Press the UP/DOWN arrow to
swap main and sub picture.
• Source - Press the UP/DOWN arrow to
select a source of sub picture.
Your choices are : TV, Video1/2, Front,
Component1/2.
RGB-PC input cannot used as PIP
screen source.
Press the EXIT button to exit Split mode.
4
Press the FREEZE button to capture and
freeze the currently-viewed sub picture in
PIP or Split mode.
If you turn on the TV to still picture for
hours, it occurs screen damage.
206-3726
tv vcr cable dvd sat
mode light power
source
video front
tv
comp1 comp2 rgb
1 2 3
4 5 6
7 8 9
0
enter
mute ratio
vol ch
swap pipch- pipch+ pip
flashbk surf freeze
menu
exit
record stop skip
pause rew
play ff
3
1/2
3
3
2/4
P A G E 2 5