Table of Contents
Advertisement
PIP/POP/SPLIT Sources
PIP (Picture-in-Picture) / POP (Picture-out-of-
Picture) / SPLIT modes let you watch main and
sub pictures at the same time.
PIP/POP/SPLIT modes turn off in instances indi-
cated below.
• Changing Aspect Ratio.
• Activating Channel Add/Del/Surf, Channel
Label, or Channel Block in Setup menu.
1
Press the PIP button on the remote con-
trol to activate PIP (Picture-in-Picture)
mode.
Use the LEFT/RIGHT arrow to select CH+/-,
2
Swap, Source or Move.
• CH+/- Use the UP/DOWN arrow to
select a program for the sub picture.
You can also use pipch-/+ button on
the remote control to change channels
for the sub picture.
Changing programs on the sub picture
is only possible if the PIP signal
source is NTSC RF signal.
If you want to change the program on
the main picture, use ch +/- button.
• Swap Use the UP/DOWN arrow to swap
main and sub picture. You can also use
swap button on the remote control to
exchange main and sub pictures.
• Source Use the UP/DOWN arrow to
select a source for sub picture.
Your choices are: TV, Video1-2, Front
video.
RGB-HD/STB, RGB-PC, and Component 1 - 2
input sources cannot be used as PIP pic-
ture sources.
• Move Use the UP/DOWN arrow to move
the sub picture on the screen.
Press the EXIT button to exit PIP mode or
3
press the PIP button again to activate
POP mode.
P A G E 2 4
Move
Source
Swap
vcr cable dvd sat
tv
mode
light
power
source
antenna
video
front
rgb
comp1
comp2
1
2
3
4
5
6
7
8
9
0
enter
mute
vol
ch
swap pipch- pipch+ pip
flashbk surf freeze
menu
exit
2
skip
record stop
pause rew
play
ff
CH+/-
ratio
1/3
2
3
206-03816
Advertisement
Table of Contents
