Vcr Hookup - Zenith D56W25 Operating Manual & Warranty

Hook Up VCR
Connect your off-air antenna and VCR to your Entertainment Machine
1
Locate the RF or VHF/UHF/CATV In jack on the back of your VCR. Connect the cable line coming
from your wall directly to this jack.
2
Locate the Antenna/Cable 1 jack on the back of your Entertainment Machine. Connect the cable
coming from the RF or VHF/UHF/CATV Out jack on the back of your VCR directly to this jack.
3
Find the composite video and audio jacks on the back of your VCR, and connect them follow-
ing the instructions provided with your equipment.
4
You may connect either the composite video or the S-video cables to Inputs 1 or 2. (Do not
connect BOTH the composite and the S- Video cables to an input set of jacks. In the event
that you connect both composite and S-Video cables, only the S-video will work.)
Turn to page 15 to continue setting up your Entertainment Machine.
Cable TV
wall jack
OR
Round wire
(75 ohm)
VCR
Back AV panel
In
3 4
Out
S-Video
Audio Video
Or
If you want to receive your signals on Channel 3 or 4, locate the Out
to TV jack on your VCR. Connect a cable from the Out to TV jack to the
Antenna/Cable 1 jack on the back of your Entertainment Machine.
For several pieces of equipment, edit the names under Source ID so
you don't forget which is which. See page 31.
P A G E 1 0
Antenna
RF coaxial wire
(75 ohm)
Or
A/V cables
not included
with TV
ANTENNA/
CABLE 1
INPUT 1
TO CABLE
BOX
S-VIDEO
VIDEO
MONO/L
ANTENNA/
CABLE 2
R
VARIABLE
AUDIO OUT
Note: Connect to either Input 1 or 2.
INPUT 2 INPUT 3
INPUT 4
S-VIDEO
VIDEO
Y/VIDEO Y/VIDEO
MONO/L
MONO/L
P P
B
B
R
P P
R
R R
MONO/L
R
206-3594