Antenna And Cable Service Hookup - Zenith D56W25 Operating Manual & Warranty

Hook Up Direct Cable TV or Antenna
Connect an off-air antenna
1
Locate the Antenna/Cable 1 jack on
the back of your Entertainment
Machine.
2
Connect the cable that runs from
the wall directly to this jack.
3
Turn to page 15 to continue setting
up your Entertainment Machine.
If you receive your RF signal through an
antenna that is several years old and con-
nects with two small prongs, you will need
to purchase a 300 to 75 Ohm adapter. It
should be available from your local
electronics dealer.
Zenith recommends using a 75 Ohm cable
for your antenna connections in order to
prevent interference.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
300 TO 75 OHM A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
ADAPTER
P A G E 8
OR
Antenna
Cable
Over-the-Air
Service
Antenna
RF Coaxial Wire
RF Coaxial Wire
(75ohm)
(75 ohm)
ANTENNA/
CABLE 1
INPUT 1 INPUT 2
TO CABLE
BOX
S-VIDEO
VIDEO
MONO/L
ANTENNA/
CABLE 2
VARIABLE
AUDIO OUT
Cable TV
Wall Jack
INPUT 3
INPUT 4
S-VIDEO
VIDEO
Y/VIDEO Y/VIDEO
MONO/L
MONO/L
P P
B B
R
R
P P
R
R R
MONITOR
OUT
S-VIDEO
VIDEO
MONO/L
L
R R
206-3489-O