Operation - Graco 258693 Instructions Manual

Operation

Dispensing Fluid in Standard Mode
All buttons are disabled while fluid is being dis-
pensed.
AUTO
Min. Dispense Volume
Minimum Flow Rate
Maximum Flow Rate
Maximum Working Pressure: 70 bar (1000 PSI)
F . 14
IG
1. If the display was blank (in
sleep mode), press and hold
the Total or Reset button. The
amount of the last dispense
appears on the display (F
14).
AUTO
Min. Dispense Volume
Minimum Flow Rate
Maximum Flow Rate
Maximum Working Pressure: 70 bar (1000 PSI)
F . 15
IG
2. Press and hold Reset button.
0.00 is shown on the display
as shown in F . 15.
IG
312668L
PTS QTS
GAL
LITERS
R-TOTAL
0.5 liter (0.13 gal)
1.0 l/min. (0.26 gpm)
19.0 l/min. (5.00 gpm)
ti12043a
.
IG
PTS QTS
GAL
LITERS
R-TOTAL
0.5 liter (0.13 gal)
1.0 l/min. (0.26 gpm)
19.0 l/min. (5.00 gpm)
ti12048a
LDM5 Meter Setup and Operation Instructions
3. Squeeze the trigger.
Fluid begins to flow, and the amount shown on the
display counts up from zero.
AUTO
Min. Dispense Volume
Minimum Flow Rate
Maximum Flow Rate
Maximum Working Pressure: 70 bar (1000 PSI)
F . 16
IG
4. Release the trigger when you have dispensed the
desired amount of fluid.
Fluid flow stops, and the amount you have dis-
pensed is shown on the display (F
When you release the trigger, the nozzle should
prevent fluid from running out of the extension. If
fluid does run out, see Replacing the Nozzle on
page 28.
PTS QTS
GAL
LITERS
R-TOTAL
0.5 liter (0.13 gal)
1.0 l/min. (0.26 gpm)
19.0 l/min. (5.00 gpm)
ti12043a
. 16).
IG
11