Configure Your System; Select A Base Model - Graco ProMix PD2K Installation Manual

Configure Your Your System
Configure Configure Your
1. 1. 1. Select Select a a a Base Base Model
Select Base
Choose a ProMix PD base model that meets your
application's requirements. See
Base models include components A through F shown
in the Typical Installation drawing on the next page.
Base unit components are described in the following
table.
Component
Component Component
Fluid Pumps (A, B)
Solvent Flow Switch (C)
Electrical Control Box (D)
Advanced Display Module (E)
CAN cable (F)
332458M
System
System
Model
Model
Models, page 3
Description Description Description
The base models include two fluid pumps, one for resin and one for
catalyst. Install in the non-hazardous area.
Confirms solvent flow to gun during purge. The base models include two
solvent flow switches; one for resin, and one for catalyst.
The electrical control box includes a barrier board, intrinsically safe
isolation board, 24 Vdc and 48 Vdc power supplies, Enhanced
Fluid Control Module, and Pump Control Modules. The Gateway
communication module is installed in the electrical control box. It accepts
90–250 Vac line power and converts that power to acceptable low voltage
signals used by other system components. Install the electrical control
box in the non-hazardous area.
The Advanced Display Module (ADM) enables the user to setup, monitor,
and control the system. Install the ADM in the non-hazardous area.
The CAN cable connects the Gateway communication module to the IS
remote mix control module.
.

Configure Your System

13