201: Sna Local Channel Control Unit Address; 211: Scs Support (Sdlc Only); 213: Between Bracket Printer Sharing (Sdlc Only); 215: Physical Unit Identification (Puid) (Sdlc Only) - IBM 3270 Manual

Specify a 0 if any of the following conditions exists:
• You do not have distributed function terminals attached
• Your system is not capable of handling BSC WACK
• Your system has IMS/VS using BTAM
e
Your system has TCAM or ACF/TCAM using 370X EP.
You must ensure that the program products being used are at compatible
levels and support the required display functions.
201: SNA Local Channel Control Unit Address
Enter 00 for this sequence number in step 8 on the Initial Customizing
Procedure Form.
211: SCS Support (SDLC Only)
Enter a 1 if the LU Type 1 SNA character string (SCS) (3287 Printer with
feature 9660, 3230 Printer, 3262 Line Printer, 3268 Printer, or 3289 Line
Printer) is used; enter a 0 if not.
ii
V
213: Between Bracket Printer Sharing (SDLC Only)
Enter a 0 if Between Bracket Printer Sharing is not allowed; enter a 1 if it
lS.
215: Physical Unit Identification (PUID) (SDLC Only)
The physical unit identification (PUID) is a 5-character code that identifies
the control unit to the host in response to an SDLC XID command. It is
required if the 3274 is to be used on a switched data link.
If the PUID is not used, enter 00000 for this sequence number in step 8 on
the Initial Customizing Procedure Form.
If the PUID is used, each control unit in a network should be assigned a
unique PUID. The PUID must be obtained from the system programmer
and entered as the response to this sequence number in step 8 on the Initial
Customizing Procedure Form.
Chapter 3. Preparing to Customize
3-53