164: Programmed Symbols (Ps) (Configuration Support C Only); 165: Decompression (Configuration Support C Only) - IBM 3270 Manual

• 3262 Models 3 and 13
• 3268 Model 2
• 3278 with Extended Character Set Adapter (feature 3610)
e
3279 Models 2B, 3B, S2B, and S3G
• 3279 Models 02X and 03X with Extended Function Store (feature 3850)
e
3287 with Extended Character Set Adapter (feature 3610)
A
2-digit number must be entered. If necessary, use a leading zero; for
example, to specify 8, enter 08.
Notes:
1. This number must not exceed the number of Category A terminals
specified in sequence number 112.
2. If an IBM 3270 Personal Computer Attachment is configured (sequence
number 114= 1), each attachment must be considered a count unless the
associated display has been counted as a display with the Extended
Character Set Adapter (feature 3610) installed.
3. If you respond 1 to this sequence number, you must not respond 08, 10,
13, 20, 26, or 27 to sequence number 121.
164: Program:med Symbols (PS) (Configuration Support C Only)
Enter a 1 if any attached terminals have a Programmed Symbols (PS)
feature (5781, 5782, or 5783) installed; enter a 0 if not.
165: Decompression (Configuration Support C Only)
3-48
Enter a 1 if you want to send compressed PS data; otherwise, enter a 0.
(This sequence number is not asked if a 0 was specified for sequence
number 164 [Programmed Symbols].)
Note: Decompressing data on a locally attached 3274 could cause
performance degradation.
\
\__)