Table of Contents
Advertisement
52
=>
Problem
Previously programmed
information is erased.
During a conversation, two
tones sound, the other line
indicator flashes quickly and
the display shows another
caller's information.
The unit does not display the
callers name and/or phone
number.
A call was received, but the
caller's information was not
recorded in the Caller List.
The display goes to the
stand-by mode while viewing
the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller's
name and/or phone number.
LOCATOR]
does not
function.
Before Requesting Help
LE
Le AE
aad
ii
de
eee,
Tee
ae
Remedy
o If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
o Someone is calling you on the other line.
To answer, press
to put the
current call on hold. Press the line button
whose indicator is flashing quickly (p. 40).
o Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
o Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
o Telephone line noise may be affecting
the Caller ID information.
o if you receive two calls at the same
time, only one of the caller's information
can be recorded.
o Do not pause for over 60 seconds while
searching.
e The line mode selection is incorrect.
See page 17.
o The handset is too far from the base
unit.
o The handset is engaged in an outside
call. Wait until the IN USE/CHARGE
indicator light goes out.
Advertisement
Table of Contents
