Advertisement
(Ref. No. 1 on page 3.)
. Remove the LCD flexible board from the
connector. (JU02)
. Remove the 4 screws of the Rear protector
retainer and open the center frame. Pull the
cassette lid ass'y. (Ref. No. 2 ©, ©, No.5 @, @
on pages 3 and 4.)
. Remove a pin at the left side as well.
. Connect the connecter (JU02) with the LCD
flexible board which is removed on No. 3.
. Press the open detecting switch with an adhesive
tape and hold the power "ON".
A tape is loading without any interference with
the cassette lid ass'y.
. Perform head position adjustment after
disassembling the unit to the point shown on the
Head alignment
Ceramic screwdriver
Apo
vo}
(Head alignment)
(HOZAN D-2981, + No. 0)
© Head height
adjusting screw (R)
Tape guide (R)
Tare quide (L)
ae
© Head height
;
Tilt acjustin
adjustin
Open detect switch
@ Sera
ve
Scie (9
(Press the open detect switch with an adhesive-tape)
Advertisement
