Lincoln Electric INVERTEC CV350-R Service Manual page 34

F-8
CASE COVER REMOVAL PROCEDURE (CONTINUED)
PROCEDURE
1. Disconnect power to the INVERTEC
2. Using a Philips head screwdriver removes the four
screws on top panel, and the six screws on both
side, see Figure F.1.
Note:
The type of two top rear side screws is self
tapping.
3. Then remove the eight screws on right panel, also
see Figure F.1.
Self Tapping Screws
Troubleshooting and Repair
TM
CV350-R.
FIGURE F.2 – LEFT PANEL SCREW LOCATIONS
INVERTEC
Note:
The type of two rear down side screws is self
tapping.
4. At last, remove the ten screws on left panel, see
Figure F.2.
Note:
The type of two rear down side screws is self
tapping.
TM
CV350-R
F-8