Table of Contents
Advertisement
PREFACE
About This Manual
This manual describes how to set-up and start to use the iU -200A/201A universal program
mer and the Intel ROM programming software (i
S) to store programs and data into pro
grammable read-only memory ( ROM) devices. It is for engineers and designers who are
developing firmware for ROM-, ROM-, E ROM-, or E 2 ROM-based systems.
The following describes the general contents of each chapter.
Chapter 1
Describes support hardware requirements and how to set up the universal
programmer.
Chapter 2
Describes how to install and initialize the i
S on an IBM C XT or C AT.
Chapter 3
Describes the power-up cycle, self diagnostics, and how to install a
ROM
device.
Chapter 4
rovides a simple, on-line (i
S) example programming session.
Conventions Used in This Book
A section of text introduced by the symbol
A section of text introduced by the symbol
Throughout this book, the iU -200A/201A universal programmer is called the universal pro
grammer and the Intel ROM programming software is called the i
S.
NOTE
emphasizes comments with special significance.
| CAUTION
gives instructions necessary to avoid damage to equipment or loss of stored information.
Other Pertinent Intel Literature
This document is a brief start-up manual, intended to be used with the UP-200A/201A Un ver
sal Programmer User's Gu de, order number 166041.
v/vi
Advertisement
Table of Contents
