Table of Contents
Advertisement
MAIN
POWER
SWITCH
(IN OFF
LINE VOLTA E
SELECTION SWITCHES
0144
Figure 1-1 Setting the Line Voltage
4.
lug the main power plug into the power source and turn on the universal programmer.
5. Install the RS-232 serial cable between the universal programmer and the host microcom
puter system (for on-line operation only) as follows:
a)
lug the 25 pin end of the RS-232 cable into the RS-232 connector on the back of the
universal programmer. Refer to Figure 1-3. The main power can be either on or off.
Connect the external ground wire of the cable to a screw on the left side of the large
black universal programmer heat sink.
b)
lug the other end of the RS-232 cable into the serial channel on the host microcompu
ter system configured as COMI or COM2 (refer to the host system ' s user manual for
host system configuration instructions). This is the serial channel number you will
specify when invoking the i
S, in most cases, this will be serial channel 1 (COMI).
6. Install a personality module.
ersonality modules adapt the universal programmer to a
particular family of ROM devices. You cannot use a personality module alone; it must be
installed in the universal programmer or an Intel personal development system (i DS™
system). The personality module plugs into the front panel of the universal programmer
(see Figure 1-4). No further connections are required. During the insertion and removal of
the personality module, the main power switch can be either on or off.
Hardware Set-Up
1-3
Advertisement
Table of Contents
