Intel iUP-FAST 27/K-U2 Installation Manual page 13

UP-Fast 27/K-U2 Upgrade K t Installat on Manual
2043
Figure 3 The iUP-Fast 27/K Printed Circuit Board
7. Refer to Figure 2 and replace the printed circuit board (2) in the front panel (3) and, using the
3/16-inch hex nut driver, secure the four hex stand-offs (7).
{cAUTh&>T|
Do not overtighten the four hex stand-offs when reassembling the printed cir ­
cuit board to the front panel. Damage to the printed circuit board may result.
8. Refer to Figure 2 and replace the base cover (1) and, using the #1 Phillips screwdriver, secure
the four screws (4), lock washers (5), and flat washers (6).
9. Place the back panel label beneath the host connector as shown in Figure 4.
10. Place the dress panel label on top of the label that is to the right of the hexadecimal display as
shown in Figure 5.
HE KOUT PRO EDURES
Perform the following checkout procedures to verify that you have installed the upgrade kit cor ­
rectly. hese procedures assume that your universal programmer or iPDS system has been initial ­
ized and is ready for use.
3