White OMEW Series Repair Instructions page 16

3. Place the needles in the outer ring and
hold them in place with grease. Now
place the whole bearing in the
housing. Press the bearing into
position with mandrel SJ 151-9000- 18
4. Carefully insert shaft through housing.
Note:
Cover the groove with installation sleeve
5. Place O-ring (5) in housing
Note:
Remember about the new O-ring
O-ring dimensions:
•
Series 0: 96 • 2 mm
•
Series 1 and 2: 100.5 • 2 mm
6. Place spring washer (13) on balance
plate (14),
insert O- ring (12) in recess and
lubricate with grease. Place balance
plate lightly in position so that it
engages. Be careful not to damage the
O-ring.
Note:
Remember about the new O-ring
7. Place disc valve (15) on the shaft
upwards so that the long tap on the
disc valve engages with the slot in the
shaft.
WHITE can accept no responsibility for possible errors in catalogues, brochures, and other printed material. WHITE reserves the right to alter its products without notice. This also applies to products already on
order provided that such alterations can be made without subsequent changes being necessary in specifications already agreed.
All trademarks in this material are the property of the respective companies. WHITE and the WHITE logotype are trademarks of WHITE Drive Motors & Steering LLC and WHITE Drive Motors and Steering Sp. z o.o..
.
All rights reserved.
16