White OMEW Series Repair Instructions page 14

8. Remove distributor plate (18) and O-ring
(5).
The needles will fall out of the needle
bearing (16) during dismantling and can be
collected for reuse. The outer ring and
thrust bearing (17) need not be removed.
9. Remove disc valve (15)
10. Remove shaft (11) With the housing
standing on the work wrench, press the
shaft out of the housing. Collect the
needles for possible reuse
11. Remove balance plate (14), O-ring (12)
and spring washer (13).
WHITE can accept no responsibility for possible errors in catalogues, brochures, and other printed material. WHITE reserves the right to alter its products without notice. This also applies to products already on
order provided that such alterations can be made without subsequent changes being necessary in specifications already agreed.
All trademarks in this material are the property of the respective companies. WHITE and the WHITE logotype are trademarks of WHITE Drive Motors & Steering LLC and WHITE Drive Motors and Steering Sp. z o.o..
All rights reserved.
14