Sony HCD-SHAKE33 Service Manual page 126

HCD-SHAKE33/SHAKE44/SHAKE55/SHAKE66/SHAKE77/SHAKE88
Ver. Date
1.4 2014.12
How to search for a contact point of signal lines or the like in DIAGRAMS SECTION
If a contact point of a BLOCK DIAGRAM, PRINTED WIRING BOARD or SCHEMATIC DIAGRAM is shown in a different page, use
the PDF fi le search function to fi nd one.
e.g.) If a contact point is shown as
Procedure:
1. Press the [F] key while pressing the [Ctrl] key.
2. Input ">001Z" in the search box and press the [Enter] key.
3. The relevant part (page), where the contact point is shown, appears.
Note: If you still see the original page, press the [Enter] key again.
Change P/N of CN1001 and CN1003 in 4CH DAMP board (SHAKE33/SHAKE44).
Change P/N of CN451 in MOTHERBOARD board.
Change P/N of CN501 and CN502 in MOTHERBOARD board (Service code changed).
Change P/N of CN901 in MOTHERBOARD board (SHAKE44/SHAKE66/SHAKE88).
Change P/N of CN5000 in VIDEO board (SHAKE44/SHAKE66/SHAKE88).
Change P/N of Ref. No. #1 and #2 in page 88, 89, 90, 91, 92 and 93.
Change P/N of REGULATOR, SWITCHING (SSNBPR) (SHAKE55/SHAKE66) in page 93 and 124.
Change P/N and description of Ref. No. 254 (SHAKE44: MY/SHAKE88: MY) in page 93 and 124.
Change P/N and description of C023 in MOTHERBOARD board (EXCEPT SHAKE33).
Change P/N and description of CN101 and CN301 in MOTHERBOARD board.
Change P/N and description of CN3000 in TUNER board.
Delete C905 in MOTHERBOARD board (SHAKE33/SHAKE55/SHAKE77).
Add CLAMP, SLEEVE FERRITE illustration in page 90 (SHAKE33/SHAKE44).
Add STOPPER, WIRING illustration in page 90.
Change CLAMP to STOPPER, WIRING on REGULATOR, SWITCHING in page 15 and 93.
Change of 4CH DAMP Board (Suffi x 22).
Change sentence for CLASS 1 LASER product in page 4.
Change P/N of Ref. No. 152 (SHAKE44) in page 91.
Change P/N of Ref. No. 258 (SHAKE33/SHAKE44) in page 93 and 124.
Change P/N of IC105 in MOTHERBOARD board.
Delete CLAMP in page 90.
, follow the procedure below.
Description of Revision