Resetting Unit To Factory Default Settings (All Models) - Miller Syncrowave 250 DX Technical Manual

4-22. Resetting Unit To Factory Default Settings (All Models)

2
1
5
1 Process Control
2 Amperage Control
3 Output Control
4 Start Control
TM-359 Page 52
3
4
5 Power Switch
To reset all welding power source functions
to original factory settings, turn power off.
Push and hold the Process, Amperage,
Output and Start controls and turn On pow-
er. Hold switch pads for approximately 7
seconds (or until software version number
_ _ _ _ _ _-_clears meters).
Syncrowave 250 DX