Section 3 − Installation; Selecting A Location - Miller Syncrowave 250 DX Technical Manual

3-1. Selecting A Location

Movement
Location And Airflow
3
18 in (460 mm)
TM-359 Page 6
SECTION 3 − INSTALLATION
1
OR
1
Y Falling Unit
S
S
S
2
1
2
Use lifting eye or lifting forks to
move unit.
If using lifting forks, extend forks
beyond opposite side of unit.
3
Use rating label to determine input
power needs.
4
Locate unit near correct input pow-
er supply.
Y Special installation may be
Y Be careful when placing or
4
18 in (460 mm)
Can Cause
Injury.
Use lifting eye to lift unit only,
NOT running gear, gas
cylinders, or any other
accessories.
Use equipment of adequate
capacity to lift and support
unit.
If using lift forks to move unit,
be sure forks are long enough
to extend beyond opposite
side of unit.
Lifting Eye
Lifting Forks
Rating Label
Line Disconnect Device
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
moving unit over uneven
surfaces.
Ref. 117 264-C / 802 455-C
Syncrowave 250 DX