Yamaha RX-V2700 Owner's Manual page 152

TROUBLESHOOTING
During Auto Setup
Error message
E01:No Front SP
E02:No Sur. SP
E03:No PRNS SP
E04:SBR->SBL
E05:Noisy
E06:Check Sur.
E07:No MIC
E08:No Signal
E09:User Cancel
E10:Internal Err.
After Auto Setup
Warning message
W1:Out of Phase
W2:Over Distance
W3:Level Error
W4:SP Mismatch
Notes
• If the "ERROR" or "WARNING" screens appears, check the cause of the problem, then run "Auto Setup" again.
• If warning "W1" appears, corrections are made, but they may not be optimal.
• If warning "W2" or "W3" appears, no corrections are made.
• If error "E10" occurs repeatedly, please contact a qualified YAMAHA service center.
148
En
Cause
Front L/R channel signals are not detected.
A surround channel signal is not detected.
A presence channel signal is not detected.
Only right surround back channel signal is
detected.
Background noise is too loud.
Surround back speakers are connected,
though surround L/R speakers are not.
The optimizer microphone was unplugged
during the "Auto Setup" procedure.
The optimizer microphone does not detect
test tones.
The "Auto Setup" procedure was cancelled
due to user activity.
An internal error occurred.
Cause
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
The distance between the speaker and the
listening position is over 24 m (80 ft).
The difference of volume level among
speakers is excessive.
The result of the wiring check of "Auto
Setup" is different from "Speaker Set" in
"Manual Setup".
Remedy
Check the front L/R speaker connections.
Check the surround speaker connections.
Check the presence speaker connections.
Connect the surround back speaker to the
LEFT SURROUND BACK SPEAKERS
terminal if you only have one surround
back speaker.
Try running "Auto Setup" in a quiet
environment.
Turn off noisy electric equipment like air
conditioners or move them away from the
optimizer microphone.
Connect surround speakers when you use
surround back speakers.
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
Check the microphone setting.
Check the speaker connections and
placement.
Run "Auto Setup" again.
Run "Auto Setup" again.
Remedy
Check the speaker connections for proper
polarity (+ or –).
Bring the speaker closer to the listening
position.
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
Check the speaker connections.
Use speakers of similar quality.
Adjust the output volume of the subwoofer.
Use "Speaker Set" in "Manual Setup" to
adjust the speaker settings manually.
See
page
16
16
16
16
—
—
16
35
35
16
35
35
See
page
16
—
—
16
—
35
105