Yamaha RX-V2700 Owner's Manual page 130

REMOTE CONTROL FEATURES
Programming macro operations
You can program your own macro and use the macro
programming feature to transmit several remote control
commands in sequence at the press of a button. Be sure to
set up remote control codes or perform learning operations
before programming the macro.
Notes
• The default macro is not cleared when a new macro is
programmed for a button. The default macro can be used again
when the programmed macro is cleared.
• It is not possible to add a new signal (macro step) to the default
macro. Programming a macro changes all macro contents.
• We do not recommend programming continuous operations
such as volume control in a macro.
1
Set the operation mode selector to AMP or
SOURCE and then press MACRO using a
ballpoint pen or similar object.
"MCR ?" appears in the display window on the
remote control.
AMP
SOURCE
TV
or
AMP
SOURCE
TV
Note
If you do not complete each of the following steps within 30
seconds, the macro programming mode will be
automatically canceled. In this case, start over from step 1.
2
Press the macro button you want to use to
operate the macro.
The macro button name (ex. "M;DVD") and the
selected component name (ex. "DVD") appear
alternately in the display window on the remote
control.
POWER
STANDBY
NET/USB
PHONO TUNER CD MULTI CH IN
V - AUX/DOCK
CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR 2 DVD
(U.S.A. model)
126
En
3
MACRO
4
Note
"AGAIN" appears in the display window if you press a
button other than a macro button.
Press the buttons for the functions you want
to include in the macro operation in
sequence.
You can set up to 10 steps (10 functions). After you
have set 10 steps, "FULL" appears and the remote
control automatically exits the macro mode. The
following example is for programming the following
procedure:
Step 1 ("MCR 1"): Press DVD.
Step 2 ("MCR 2"): Press AV POWER.
Step 3 ("MCR 3"): Press SLEEP.
POWER POWER STANDBY POWER
TV AV
2
NET/USB AUDIO SEL SLEEP
3
PHONO TUNER CD MULTI CH IN
V-AUX/DOCK CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR 2 DVD
1
(U.S.A. model)
Indicates the
number of macro
steps entered
Flashes alternately so you can
set the next step
Note
To change the selected input area, press SELECT k
Pressing the input selector buttons will program a macro step,
whereas SELECT k / n
only changes the selected input area.
Press MACRO again using a ballpoint pen or
similar object when the operation sequence
you want to program is complete.
Note
"ERROR" appears in the display window if you press more
than one button simultaneously.
MCR 2: AV POWER
MCR 3: SLEEP
MCR 1: DVD
/ n
.