Yamaha RX-V2700 Owner's Manual page 147

XM Satellite Radio (U.S.A. and Canada models only)
If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel
display. In this case, read the cause and follow the corresponding remedies.
Status message
CHECK ANTENNA The XM Passport and XM Passport Home
Dock are not connected to the XM jack of
this unit or do not work properly.
UPDATING The XM user encryption code is being
updated.
NO SIGNAL The signal is too weak.
LOADING It takes longer than four seconds for audio
or text data to be decoded.
OFF AIR The XM Satellite Radio channel you
selected is not currently broadcasting any
signals.
<XM> - - - The Channel Station ID (SID) is no longer
available.
- - - / - - - No artist name or song title is available.
<CAT> - - -
No channels are available for the selected
category.
Remote control
Problem
The remote control Wrong distance or angle.
does not work or
function properly.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The batteries do not last long and get
quickly exhausted.
The operation mode selector is set
incorrectly.
The remote control code was not correctly
set.
The library code of the remote control and
the remote control ID of this unit do not
match.
Cause
Check XM Passport and XM Passport Home Dock
connections and orient for the best reception level.
Wait until the encryption code is updated.
Adjust the orientation of the XM Passport System for
the best reception level.
Wait until the decoding process has finished.
Check the channel number again or select another
XM Satellite Radio channel.
Select another channel category by pressing
CATEGORY on the front panel (or A-E/CAT. j / i on
the remote control) repeatedly.
Cause
The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
Using alkaline batteries is strongly recommended.
Set the operation mode selector correctly.
When operating this unit, set it to the AMP position.
When operating the component selected by the input
selector button, set it to the SOURCE position.
When operating the TV set in the DTV or PHONO
area, set it to the TV position.
Set the remote control code correctly using
"LIST OF REMOTE CONTROL CODES" at the end
of this manual.
Try setting another code of the same manufacturer
using "LIST OF REMOTE CONTROL CODES" at
the end of this manual.
Match the remote control ID of this unit with the
corresponding remote control library code.
TROUBLESHOOTING
Remedy
Remedy
See
page
63
—
63
—
—
69
See
page
11
—
11
—
—
120
120
121, 135
143
En