Yamaha RX-V2700 Owner's Manual page 151

iPod
Note
In case of a transmission error without a status message appearing in the front panel and on the video monitor, check the connection to
your iPod (see page 29).
Status message
Loading...
This unit is in the middle of recognizing
the connection with your iPod.
This unit is in the middle of acquiring
song lists from your iPod.
Connect error
There is a problem with the signal path
from your iPod to this unit.
Unknown iPod
The iPod being used is not supported by
this unit.
iPod connected
Your iPod is properly stationed in a
YAMAHA iPod universal dock (such as
the YDS-10, sold separately) connected to
the DOCK terminal of this unit, and the
connection between your iPod and this
unit is complete.
Disconnected
Your iPod was removed from a YAMAHA
iPod universal dock (such as YDS-10 sold
separately) connected to the DOCK
terminal of this unit.
Unable to play
This unit cannot play back the songs
currently stored on your iPod.
Auto Setup
Before Auto Setup
Error message
Connect MIC!
Unplug Phones!
No Setup Menu!
Memory Guard!
Cause
Cause
Optimizer microphone is not connected.
Headphones are connected.
All setup menu are set to "Skip".
"Memory Guard" is set to "On".
Remedy
Turn off this unit and reconnect the YAMAHA iPod
universal dock to the DOCK terminal of this unit.
Try resetting your iPod.
Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported.
Station your iPod back in a YAMAHA iPod universal
dock (such as YDS-10 sold separately) connected to
the DOCK terminal of this unit.
Check that the songs currently stored on your iPod
are playable.
Store some other playable music files on your iPod.
Remedy
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
Unplug the headphones.
Set the desired menu item to "Check".
Set "Memory Guard" to "Off".
TROUBLESHOOTING
See
page
29
—
—
29
—
—
See
page
35
—
36
114
147
En