Speaker Impedance Setting; Turning On The Power - Yamaha RX-V1500 Owner's Manual

Speaker impedance setting

CAUTION
If you are using 6 ohm speakers, set the impedance to
6 ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1
On the front panel, while holding down
SPEAKERS A, press STANDBY/ON.
"SP IMP.SET" appears in the front panel display for a
few seconds, then "Minimum 8ohms" appears.
SPEAKERS
A
S P I M P . S E T
M i n i m u m 8 o h m s
2
Press SPEAKERS A or SPEAKERS B to
select the impedance of your speakers.
You can select either 6 ohms or 8 ohms.
3
Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
y
You can also use SP IMP.SET (see page 63) to set the speaker
impedance.
When all connections are complete, turn on the power of
this unit.
1
STANDBY
/ON
1
2
Note
Press STANDBY/ON again (STANDBY on the remote control)
to enter the standby mode.

Turning on the power

INPUT
PURE DIRECT
STANDBY
/ON
PRESET/ PRESET
A/B/C/D/E TUNING /TUNING
TUNER
SPEAKERS MULTI CH INPUT MODE
EDIT
INPUT
A B
YPAO
OPTIMIZER
MIC
POWER POWER
TV AV
A B
PHONO TUNER
V-AUX CBL/SAT
DTV VCR 1
+ +
Press STANDBY/ON (SYSTEM POWER on the
remote control) to turn on the power of this
unit.
STANDBY
/ON
Front panel
Turn on the video monitor connected to this
unit.
CONNECTIONS
VOLUME
TUNING
FM/AM MEMORY MODE
PROGRAM
MAN'L/AUTO FM AUTO/MAN'L MONO TONE CONTROL
STRAIGHT
PHONES S VIDEO VIDEO L AUDIO R OPTICAL
EFFECT
SILENT VIDEO AUX
(U.S.A. model)
SYSTEM
STANDBY POWER
1
INPUT MODE SLEEP
CD MULTI CH IN
MD/TAPE CD-R
DVR/VCR2 DVD
SELECT
AMP
+
SYSTEM
POWER
or
Remote control
25