Advanced Operation; Advanced Operations; Selecting The Osd Mode; Using The Sleep Timer - Yamaha RX-V1500 Owner's Manual

ADVANCED OPERATIONS

Selecting the OSD mode

You can display this unit's operating information on a
video monitor. If you display the SET MENU and sound
field program parameter settings on a monitor, it is much
easier to see the available options and parameters than it is
by reading this information in the front panel display.
1
Turn on the video monitor connected to this
unit.
2
Press ON SCREEN repeatedly to change the
OSD mode.
The OSD mode changes in the
following order: full display, short
display, and display off.
Full display
Always shows the sound field program parameter
settings as well as the contents of the front panel
display.
Short display
Briefly shows the contents of the front panel display
at the bottom of the screen each time you operate this
unit.
Display off
Only operations performed using ON SCREEN are
displayed. The OSD is displayed when using SET
MENU or the test tone feature, even if the OSD mode
is set to "Display off".
P08 Sci-Fi
. DSP LEVEL;;;;0dB
P.INIT DLY;;16ms
P.ROOM SIZE;;1.0
S.INIT DLY;;20ms
S.ROOM SIZE;;1.0
Full display
Notes
• The OSD signal is not output to the REC OUT jack, and will
not be recorded.
• When the component video signals are input, short display is
not output to the COMPONENT VIDEO MONITOR OUT
jacks.
• You can set the OSD to turn on (gray background) or off when a
video source is not being reproduced (or the source component
is turned off) by using DISPLAY SET (see page 62).
50
ADVANCED OPERATIONS
ON SCREEN
DISPLAY
P08 MOVIE THEATER
Sci-Fi
Short display

Using the sleep timer

Use this feature to automatically set this unit in the
standby mode after a certain amount of time. The sleep
timer is useful when you are going to sleep while this unit
is playing or recording a source. The sleep timer also
automatically turns off any external components
connected to the AC OUTLET(S).
Setting the sleep timer
POWER
TV
A
PHONO
V-AUX
DTV
1
Select a source and start playback on the
source component.
2
Press SLEEP repeatedly to
set the amount of time.
Each time you press SLEEP, the front
panel display changes as shown
below. The SLEEP indicator flashes
while switching the amount of time for
the sleep timer.
SLEEP 120 min.
SLEEP OFF SLEEP 30 min.
V–AUX DVR/VCR2 VCR 1 CBL/SAT
SP
A
S L E E P
SLEEP
The SLEEP indicator lights up in the front panel
display, and the display returns to the selected sound
field program.
V–AUX DVR/VCR2 VCR 1 CBL/SAT
SP
A
C O N C E R T H A L L
SLEEP
TRANSMIT
SYSTEM
POWER STANDBY POWER
AV
2
B INPUT MODE SLEEP
TUNER CD MULTI CH IN
CBL/SAT MD/TAPE CD-R
VCR 1 DVR/VCR2 DVD
SELECT
SLEEP
SLEEP 90 min.
SLEEP 60 min.
DTV DVD MD/TAPE CD–R CD TUNER PHONO
1 2 0 m i n
DTV DVD MD/TAPE CD–R CD TUNER PHONO
dB
VOLUME
L L R
dB
VOLUME
L L R