Table of Contents
Advertisement
Adjusting
the sound
field
and
sound
quality
a
AOS
REA
EH HASSE
ESHASASE
ECE
SESS
EH HERETO TH ESTER
ARE
Equalization-level display
POKES
TERS
FERE
SET
TETAREOE
À n
EQUALIZER LEVEL CONTROL
ne AL
hee
2B
2
er PLA RAN
Characteristic of each frequency range
The followings are the examples of typical applications with
regards to the equalizer band settings.
These statements are used in a general manner of speaking and
may not hold true in all cases.
Deep bass range
The sounds
of the bass, drums,
etc. are dramatically
strengthened.
Bass range
This range provides the sounds of the saxophone, trombone, etc.
sounds can be clarified, if indistinct, by reducing this setting.
Using the graphic equalizer
For SD-S948*S748*SH-GS71
Adjusting the tone quality
è Turn Dolby Pro Logic and the SFC mode OFF.
e Set the TREBLE and BASS tone controls to their center positions.
Press POWER of the graphic equalizer.
The graphic equalizer will switch on.
Start the desired sound source.
Press EQ LEVEL.
(The equalization-level display will be shown.)
Adjust the left and/or right channe! tone quality as
desired. (See below.)
Upper row: These buttons are used to increase the level of
each sound range (frequence range).
Lower row: These buttons are used to reduce the level of
each sound range (frequency range).
As with any equalizer, it is not recommended
to raise
adjacent equalizer level controls by a large amount. This may
cause amplifier clipping, distortion, or damage to the
speakers. It is more effective to raise one equalizer level
control and lower the ones on either side, especially if you
want to emphasize a particular sound like a drum.
To bypass the graphic equalizer ZI
Press EQ ON/OFF to select the "EQ OFF" mode.
Press once again to turn on the equalization effect.
For your reference
Bypass is possible even when power to the graphic equalizer is
OFF.
Mid-bass range (the fundamental range for
music)
This control can be used to reinforce the sounds of male vocals,
etc.
Ci kHz | Mid-range
This control can be used to add clear presence and realism to
female vocals, etc.
Mid-high range
This range provides clarity and color variations to stringed
instruments, etc.
Treble range
This control can be used to brighten the sounds of the flute and
similar instruments. If sounds seem too jarring, a softness can be
applied by reducing the setting.
Advertisement
Table of Contents
