Technics SD-5948 Operating Instructions Manual page 35

è REC PAUSE
OPEN
Es Forward side
evpeseeoseseauneorae ereereeenacone eveeseeneseooncen
Reverse side
DOLBY NA
k 2g
"mh "8 90 8 SG & 2 HA
a
REVERSE
FT
MODE K 2m), uu
me
COCO H RAO REEEHORE CTH RESO HS eeereeseeeenonnn eeoneseseonsone eneeseonnoanen t..
@ REC PAUSE
Y
eeeeeeaeneanacone eneeseeernaonneoers eeeesesoanenne eeeeeeereanneosn enesemnnse
©
{
FORUELESOSRSSESEERECESIOCORE i
peaeanatanenannn
Type of tape which can be used for recording:
Load a tape which has been advanced to the end of the leader tape
(the transparent part at both ends of the tape) into Deck 2.
Turn on the power of the systems.
Press A OPEN on Deck 2, and then insert the
cassette tape.
Push the cassette holder closed by hand.
Press DOLBY NR to record by Dolby B-type noise-
reduction system.
When recording a tape without using a Dolby NR system,
press so that the indicators go off.
Press REVERSE MODE to select the desired
reverse mode.
Each time the button is pressed, the indicator will change in
the order: PEE E
== : Only one side will be recorded, and then operation
will automatically stop.
: Both sides (the forward side first, and then the
reverse side) will be recorded, and then
operation will automatically stop.
>.
Press @ REC PAUSE.
The unit will be in the recording standby mode.
Press to select the desired source to be recording.
Press > (or 4) to begin recording, and play the
source to be recorded.
>: To begin recording from the forward side.
4: To begin recording from the reverse side.
When recording on both sides of the tape, be sure to press the
> button.
esssnnoru eeeeteesennene eeeerereesonnen aeseeseenacne peeeseensenaonser aeseesenaseone
To stop recording
Press W.
To temporarily stop recording
Press @ REC PAUSE.
To resume recording
Press either 4 or P, corresponding to the side of the tape side
indicator (<j or P>) which is lit.
2
o
$
ke]
é