Listening To Radio Broadcasts; To Listen To The Radio Without Presetting Stations - Technics SD-5948 Operating Instructions Manual

Table of Contents

Advertisement

TAPE MONITOR
STANDB
mnopnnaonas
LEELEE E ETTET EETEETTETEETTETTEETTTTETTTTETTTZTYTITTTITT]
tottttornvonnonnonngop
CHF OEHTOO
CECE HE CEH TOP
ES RTECS NASER
SRECEREEE
seececesee
SOPOT
OR SO REP Pe OTE
OF ETO
EEE
eRE
SEE
eS ORCC
ROCe
Hee
Hee
heehee
neananES
BAND
On the tuner's display
Lif
i)
HA
ng
i
7
PRTHHHRTSOCCOPESRA
OPE
TOOT
E RE SSR ECHR
ESE OCC
e eee
ee eetnu
ste
BBeEETSaEaEe
ESS ,
DIRECT TUNING
NI
|
zal
. Ryo |
Lights up when an FM stereo broadcast is received
SC
Reeseeteouneunenaeee
SHPOST
OCF
ECCS
Het
ETeBSeE
SSR
ESae
eeseeeeeeeeesresteres
VOLUME
Listening to radio broadcasts
To listen to the radio without presetting stations
Specify the frequency using the numeric buttons to directly tune to
the desired broadcast station.
Press POWER of the amplifier and tuner.
First switch on the power of the amplifier.
The units will switch on.
At power ON, if the "TAPE
MONITOR"
indicator
flashes on the amplifier display
Press TAPE MONITOR and check the indicator goes out.
Press SPEAKERS to turn on the speaker systems.
Press TUNER.
Press BAND to select "FM" or "AM".
Press DIRECT TUNING.
OOS
ew
(While cursor display is flashing [approx. 10 seconds])
Press the appropriate numeric buttons to enter the
frequency.
If the desired FM frequency is 107.9 MHz
m-oa-
If the frequency has been input correctly, the frequency
display will blink.
1. If no button is pressed while the cursor display is flashing,
the display will return to the frequency which is currently
being received. To re-specify the frequency, repeat the
procedure from step 5.
2. If the frequency has not been input correctly, the frequency
display will blink rapidly. In this case, re-enter the
frequency.
Turn VOLUME to adjust the volume level.
If noise is excessive in the FM stereo mode
Press FM MODE. (The "MONO" indication will lights up.)
The broadcast will be monaural, but noise will be reduced. If the
button is pressed once more, stereo mode will be resumed.
After listening is finished
Be sure to reduce the volume level, and switch the power to the
standby condition by pressing POWER of the amplifier.
The power for the system can thereafter be switched on and to the
standby condition by using the power switch of the amplifier.
(provided that the power cords are connected as on page 6.)
=
=
2
2
wed

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sd-s748Sh-gs71Sd-5938Sd-s738

Table of Contents