Sony Professional BVU-900P Operation Manual page 38

TLPO
This is to set the position of title characters on the display. Use 1 to 7 for small
characters, and 1 to 5 for large.
0: Erase the title character display *
1 to 7 (or 5): Set the position of the title characters
= | >
Ce 1~7 (5)
\ieareneneet eens _,
If the title characters and time code characters are set to the same position, the title
characters have priority.
The title characters displayed in the title set area are erased, and then the title
characters which is stored in the memory by the ST command will be displayed.
The title characters set in the title set area are stored in the memory. These will not
be erased even if the power is turned off. Use the LD command to recall them.
* Do not set to 0 to enter characters.
37 (E) .