Sony Professional BVU-900P Operation Manual page 18

AC IN (power inlet)
Plug in the supplied AC power cord to supply power to the BVU-900P.
75 Q (ohm) termination switch
REF VIDEO IN (reference video input) connectors (BNC type)
RF (off tape FM signal output) connector (BNC type)
@ REMOTE 2 (24P) connector
This connector is for system expansion. For the use of this connector and its pin
assignment, see the maintenance manual.
REMOTE 1 (9P) connector
Use the supplied 9-pin remote control cable to make the connection.
@ VIDEO OUT (output) connectors (BNC type)
A composite video is output from these connectors. Connect to the video input
connector of a VTR or a video monitor.
REF VIDEO OUT (reference video output) connector
This output can be used when a BKU-903A time base corrector is installed. The signal
being output is the same as the signal being input to the REF VIDEO IN connector 8.
When a signal is not input, the reference signal generated by the BKU-903A time base
corrector will be output.
TIME CODE OUT (output) connector (BNC type)
Time code is output from this connector during playback. Connect to the input
connector of an external time code generator/reader.
@ AUDIO OUT (output) connectors (XLR 3-pin)
Audio signals are output from these connectors. The output level is controlled by the
AUDIO LEVEL controls located on the control panel. For editing, connect to the audio
input connectors of a recorder.
17 (E)