Sony Professional BVU-900P Operation Manual page 19

initiiiitil
AUDIO OUT MONITOR (audio monitor output) connector (XLR 3-pin)
Connect to audio equipment for monitoring. The output is selected with the AUDIO
MONITOR selector located on the control panel.
@® DUB OUT (dubbing output) connector (7-pin)
Use to supply the video signal to be dubbed to a U-matic VTR. Connect to the dub in
connector of the U-matic VTR using the VDC-5 7-pin dubbing cable.
TBC REMOTE (time base corrector remote control) connector
When a BKU-903A time base corrector (optional) is installed, connect the BVR-55P
remote controller supplied with the BKU-903A.
MONITOR VIDEO (monitor video output) connector (BNC type)
This outputs the video signal for monitoring. Connect to the video input connector of
a color monitor. Information superimposed on a picture in the dial menu operation
mode will also be output.
MONITOR (monitor output) connector (8-pin)
Connect to the VTR connector (8-pin) of a video monitor with a monitor connecting
cable such as the VMC-3P/-5P/-10P (optional). Through this cable, both video and audio
signals can be monitored. An audio signal(s) selected with the AUDIO MONITOR
selector located on the control panel will be output. Information superimposed on a
picture in the dial menu operation mode will also be output.
@ EXT TBC (external time base corrector) switch
Selects an external time base corrector when a BKU-903A plug-in time base corrector
(optional) is not installed.
ON: Set to this position to use with a stand-alone time base corrector.
OFF: Normally, set to this position if a time base corrector is not used.
When this selector is set to ON and a BKU-903A is installed, the BKU-903A will be
used instead of the externally connected time base corrector.