Appendix B: 4/2 Reporting Codes; Table 10: 4/2 Reporting Codes - Bosch FPT-DACT Operations & Installation Manual

FPT-DACT | Operation & Installation Guide |

Appendix B: 4/2 Reporting Codes

Table 10 lists the 4/2 codes supported by the FPT-DACT Fire Communicator. See RPT CODES for programming
information.

Table 10: 4/2 Reporting Codes

4/2 Report Code Keypad
Number Key
SYSTEM IN TST* [1]
SYS IN RPT* [2]
SILENCE* [3]
FIRE DRILL* [4]
FIRE DRL RST* [5]
OPEN RST RPT [6]
LOW BATTERY [7]
LOW BATT RST [8]
AC FAILURE [9]
AC FAIL RST [1]
AUTO TST RPT [2]
OFF NORM TST [3]
PHONE 1 TRBL [4]
PN 1 TRB RST [5]
PHONE 2 TRBL [6]
PN 2 TRB RST [7]
SYSTEM TROUB* [8]
SYS TRB RST* [9]
MAN TST RPT [1]
DATA LOST RP [2]
EEPROM FAIL [3]
RESET REBOOT* [4]
SMK PWR TBL [5]
SMK PWR RSTR [6]
GND FLT TRBL [7]
GND FLT RSTR [8]
* Item is sent only when the FPT-DACT is configured to communicate with a D8024 or D10024/D10024A Analog FACP.
** Item is for future use.
1/05 | F01U002505B
Appendix B
Group Definition
Number
1 System in Test. Sent for Walk Test operations.
1 System in Test Restore. Sent for Walk Test operations.
1 Silence. Sent when the [SILENCE] key is pressed.
1 Fire Drill. Sent for fire drill operations.
1 Fire Drill Restore. Sent for fire drill operations.
1 Open Reset Report. Sent when the [RESET] key is pressed.
1 Low Battery: Sent when a low battery input is active.
1 Low Battery Restore. Restoral occurs when a low battery input is active.
1 AC Failure. Sent when an AC Fail input is active.
2 AC Failure Restore. Restoral occurs for AC Failure.
2 Automatic Test Report. Sent for automatic communicator tests.
2 Off Normal at Test. Sent if the control panel is off-normal at the Automatic
Test time.
2 Phone Line 1 Trouble. Sent for Phone Line 1 problems.
2 Phone Line 1 Trouble Restore. Sent for Phone Line 1 problems.
2 Phone Line 2 Trouble. Sent for Phone Line 2 problems.
2 Phone Line 2 Trouble Restore. Sent for Phone Line 2 problems.
2 System Trouble. Sent for general system problems.
2 System Trouble Restore. Sent for general system problems.
3 Manual Test Report. Sent for manual communicator tests.
3 Data Lost Report. Sent if events occur too rapidly.
3 EEPROM Failure. Sent for EEPROM problems.
3 System power up and reboot.
3 Smoke Power Trouble. Sent for smoke detector power supply problems.
3 Smoke Power Trouble Restore. Sent for smoke detector power supply
problems.
3 Ground Fault Trouble. Sent for ground fault trouble problems.
3 Ground Fault Trouble Restore. Sent for ground fault trouble problems.
EN | 47