Table of Contents
Advertisement
FPT-DACT | Operation & Installation Guide |
2.0
Installation
You can install the FPT-DACT up to 500 ft (152 m) from the FACP.
2.1
Mounting the Enclosure
The FPT-DACT and its enclosure are shipped together. Install the FPT-DACT inside the enclosure. The hardware
for mounting the FPT-DACT to the enclosure is located in the hardware pack.
To mount the FPT-DACT Enclosure:
1. Remove the desired wire knockouts on the enclosure (see Figure 2).
Figure 2: Wire Knockout Locations
1
1 - Wire knockouts
2 - Self-tapping screw
3 - Machine screw
2. Using the FPT-DACT case as a template, mark the mounting hole locations on the desired wall.
3. Hang the case on the wall using the appropriate installer-supplied mounting screws (see Figure 3).
Figure 3: Mounting FPT-DACT Case to Wall (Inside View)
1 -
Position enclosure with this end up
2 -
Mount enclosure to the wall here.
3 - Snap mounting clip onto the enclosure lance. See Figure 5 on page 12.
1/05 | F01U002505B
2.0 Installation
2
4
1
3
5
4 - Right exterior
5 - Left exterior
2
1
1
3
EN | 9
Advertisement
Table of Contents
