Fluke 802EN User Manual page 15

To set the sensitivity for the external sensor:
1. Turn on the Product while pushing  at the same
time.
The screen shows the model number and software
version number.
2. Push  again to enter the sensitivity setting.
The screen below shows that the initial value is 10.00,
which means 10.00 mV/m/s².
You must set the sensitivity in mV/m/s² units.
3. Push  () or  () to enter setting mode. 10.00
flashes.
4. In setting mode (when the reading flashes), push  to
increase 0.01, or push  to decrease 0.01. The unit is
mV/m/s².
5. When you get the required sensitivity, push  to
save the setting and exit setting mode.
The external sensor can be purchased separately.
Set the sensitivity according to the reference data
that is shipped with the external sensor.
Vibration Meter
How to Operate
Note
Note
11