Save Measurement Reading - Fluke 802EN User Manual

802EN
Users Manual
Figure 1. Correct and Incorrect Measurement Angles
90˚
8
After startup, the Product is in standby mode. The main
screen shows "----" and the last set measurement unit.
1. Push and hold  to enter measurement mode and
view measurement reading.
2. When the reading is stable, release . The reading is
automatically held. The screen shows HOLD and flashes
SAVE, reminding you to save the reading.
3. Push  again to switch to the main screen in
standby mode.
The Product cannot measure frequency, because
the vibration frequency is unknown. Change the
measurement mode between LO and HI. If the two
readings are different, use the greater reading to
determine the vibration status.

Save Measurement Reading

After the measurement is completed, the measurement
reading is automatically held. The screen flashes SAVE.
Push  to save the reading. SAVE no longer flashes on
the screen. Instead, the memory location shows on the
upper-left of the screen. Quick measurements are saved as
sequential files that start at 01. For example, P03 means the
reading is saved in the 3rd file.
Note