Table of Contents
Advertisement
Recording
Press the button corresponding to the source to be recorded:
— 15 for an auxiliary source.
— 12 for an audio digital disk.
— 11 for a radio broadcast.
— 10 for records (33 or 45 rpm).
Adjust the volume to your liking. The volume control does not affect the
quality of the signal being recorded.
Tape copy
You can copy recordings if you have another tape recorder at your
disposal (recorder 2) connected to sockets 21 and 28:
® Copy from recorder 1 (playback) onto recorder 2 (recording).
— Press button 13: The TAPE 1/Monitor lamp lights up.
® Copy from recorder 2 (playback) onto recorder 1 (recording).
— Press button 14: the TAPE 2/DAT lamp lights up.
Note: Tape recorder 2 can be replaced by a hifi video cassette
recorder.
Checking the recording standard
You can check the standard of the recording being made if your
recorder has a supplementary magnetic head allowing the recording to
be monitored simultaneously.
This is only possible with a recording made by recorder 1. To do this
connect the recorder to the jacks 22 and 27.
— Press one of the buttons 10, 11, 12, 14 or 15, depending on the
source to be recorded.
— Press button 13: the TAPE 1/Monitor lamp lights up.
Balance
Direct 6 key must be released.
The Balance 5 is correctly set if the sound during mono playback
appears
to be coming
from a point half-way between
the two
speakers.
Loudness filter
At low volumes the human
ear is less sensitive to high and
frequencies than it is to medium frequencies. By depressing butt
the tone is automatically adjusted according to the degree of volui
Tone controls
— Direct 6 keys must be released.
|
— Control 3 can be used to raise (+) and lower (-) the basses; control
raises and lowers the trebles.
|
Optimum settings depend on room acoustics and speaker arrangé
ment.
— Press key Direct 6 to suppress the function of these cont
Frequency response is linear.
CD/Source Direct
In order to optimise the particularly good reproduction quality of the
it is possible to bypass the tone and balance controls so that the sign
is fed to the power amplifier from the input virtually without any |
— Press key Direct 6.
— The amplifier has a linear frequency response.
Headphones
The headphone impedance must be between 8 and 600 Q and t
cable plug diameter 6.35 mm.
Connect your headphones to jack 2. To listen on the headphones al
depress buttons 7 and 8 to release them.
Advertisement
Table of Contents
