Sample Pages; Power Saver Settings - Xerox Phaser 4510 User Manual

1.
On the control panel, select
2. Select
Information Pages
3.
Select Configuration Page
print.
Note: You can also print information pages from CentreWare Internet Services (IS) and from
the printer driver.

Sample Pages

Your printer comes with a set of sample pages that demonstrate different printer functions.
To print the sample pages:
1. On the control panel, select
2. Select
Sample Pages
3.
Select the desired sample page, and then press the OK button to print.
See also:
Advanced Features Guide at

Power Saver Settings

Factory Default:
■ Power Saver: On
■ Power Saver Timeout: 4 minutes
You can change the default power saver time on the control panel or through CentreWare IS.
Using the Control Panel:
1. On the control panel, select
2.
Verify that
Power Saver
the OK button to switch between
3.
Select
Power Saver Timeout
4. Press the OK button.
Using CentreWare IS:
1. Launch your web browser.
2. Enter the printer's IP address in the browser's Address field.
3. Select Properties.
4. Select the General folder on the left nagivation panel, then click Printer Defaults.
5.
In the User Preferences section, set the Power Saver option to On.
6. Select the new time from Power Saver Timeout.
7.
Click the Save Changes button.
, and then press the OK button.
Information
, and then press the OK button.
or Supplies Usage Page
, and then press the OK button.
Information
, and then press the OK button.
www.xerox.com/office/4510support
>
Printer Setup Printer Controls
is . If Power Saver is
On
and .
Off On
to select the new time.
Phaser® 4510 Laser Printer
1-9
, and then press the OK button to
, then press the OK button.
, then select
Off Power Saver
Control Panel
and press