Dometic 9500E Operating Instructions Manual page 8

J. Close Awning Manually (Power Failure)
In case of power failure, the awning may need to be closed
manually.
Note: See "Troubleshooting" section to diagnose cause of
power failure before following this procedure.
If faulty remote, power source failure, or connection issues
are ruled out as the cause, then there may be an issue
with the awning motor or motor wiring. Contact a qualified
Dometic service technician.
Tools required:
3/8" Open End (or Box End) wrench
Flat Bladed Screwdriver
1. Remove power from awning.
ELECTRICAL SHOCK HAZARD. Make sure
power is removed from awning before remov-
ing end caps. There may be issues mimick-
ing a power failure with electric current still
present, or power may return unexpectedly.
Failure to obey this warning could result in
death or serious injury.
2. Using a flat bladed screwdriver, disengage (2)
tabs (starting with bottom tab) on LH end cap.
Then remove from cassette awning. See FIG. 11
and 12.
FIG. 11
LH End Cap
Lead Rail
FIG. 12
LH End Cap Tab
RH End Cap
Tab
LH End Plate
3. Turn the hex rod at LH end plate clockwise until
awning is closed. See FIG. 11 and 13.
Note: Awning may not close completely. Up to a 4" gap
between lead rail and awning case may be expected.
This step will confuse the set limits, requiring limit reset(s)
once power issue is resolved. See "Set / Reset Awning In-
termediate Position" and "Reset Awning Out Limit" sections.
FIG. 13
LH End
Plate
4. Reinstall LH end cap onto cassette awning. See
FIG. 11.
5. Contact a qualified Dometic service technician for
repair.
K. Battery Replacement
Remote:
1. Remove cover screw and back cover from re-
mote. See FIG. 9.
2. Remove old Li-MnO2 battery and discard. See
FIG. 14.
3. Place and slide new Li-MnO2 battery (type
CR2430) into battery clip until fully engaged. See
FIG. 14.
Note: Make sure battery has positive side up.
FIG. 14
Battery
Battery Clip
(CR2430)
8
Hex Rod
Program Button