Selecting Postscript Fonts; Selecting Pcl Fonts - Xerox DocuPrint 100 User Manual

MICR fonts

Selecting PostScript fonts

Selecting PCL fonts

2-14
To select a Xerox Postscript font, set the attributes for one
of the following:
·
Internal name: E13B
Point size: 9.12
·
Internal name: E13B9
Point size: 9
·
Internal name: CMC72510
Point size: 9.06
The Postscript E13B MICR font has the same character
mappings as the PCL fixed pitch E13B font. Refer to the
Generic MICR Fundamentals Guide for a complete listing
of the character mappings.
The following HP PCL escape sequences are used to
select the Xerox PCL MICR fonts:
·
E13B 300 and 600 dpi font:
<ESC>(0U<ESC>(s0p8.00h9.00v0s0b0T
·
CMC7 600 dpi font (DP 100/115/135/155/180 EPS
only):
<ESC>(1U<ESC>(s0p8h9.1v0s0b0T
Refer to the Generic MICR Fundamentals Guide for a
complete listing of the fixed pitch E13B and CMC7 MICR
font characteristics and character mappings. The
character mappings relate the input character to the
printed character.
If both the 300 and 600 dpi E13B fonts have been loaded
on the printer, the font is selected based on the PCL Unit
that was specified. The default PCL Unit is 300.
You can use the PCL Unit of Measure command to set the
PCL Unit to 600 (for example, <ESC>&u600D).
Alternatively, you can override the resolution to 600 dpi in
the queue. Refer to "Setting the font resolution," later in
this chapter, for information on setting the resolution in the
queue.
MICR User Guide