Xerox DocuColor 2060 Maintenance Manual page 40

Fuser oil
3-2
3. Locate the fuser oil reservoir cap.
Figure 3-2. Fuser oil reservoir cap
4. Open the reservoir cap by grasping the tab at the back of the
cap and pulling it forward.
5. Remove the cap from the bottle of fuser oil and replace it with
the filler spout cap. This cap was provided to you when your
printer was installed. Contact your service representative if
you cannot locate the filler spout cap and need another one.
6. Carefully insert the filler spout into the opened fuser oil
reservoir and squeeze the bottle until the oil reaches the
maximum fill level tab visible inside the reservoir.
7. Remove the filler cap from the bottle and place it on a cloth or
paper towel to drain. Return the original cap to the bottle of
fuser oil.
8. Close the reservoir cap, ensuring that it snaps into place.
9. Close the printer right front door.
Guide to Performing Routine Maintenance