Software, Firmware, Hardware, And Paper Requirements; Operator Tasks For The Bypass Transport - Xerox 4850 Installation Planning Manual

Printer components and options

Software, firmware, hardware, and paper requirements

Operator tasks for the bypass transport

3-12
The optional bypass transport requires the following:
• Dual stacker output module
• Standard white, colored, predrilled, or preprinted paper.
To minimize paper jams and misfeeds, use 20 pound or 80
gsm (grams per square meter) bond xerographic grade.
Xerox 4024 Dual Purpose Paper and Xerox 10 Series Dual
Purpose paper are optimal. Use paper with less than 6%
moisture content so that the paper will not curl and jam.
NOTE: The time between sheets exiting the bypass transport for
8.5 by 11-inch / 216 by 279 mm paper, A4 paper, and 8.5 by 14-
inch / 216 by 352 mm paper is 492 milliseconds in simplex mode
and 1052 milliseconds in duplex mode. All times are measured
between the trail edge of the exiting sheet and the lead edge of
the next entering sheet.
To use the bypass transport and third-party finishing devices, you
must perform several tasks:
• Install and remove the bypass transport.
• Set up DFA personality profiles to provide the NPS/IPS with
information about each finishing device.
• Prepare the finishing device hardware necessary to finish the
printed output and inform the NPS/IPS of device names and
parameters.
• Enter appropriate commands at the printer controller to
initiate finisher jobs.
• Clear paper jams in the bypass transport.
You learn how to install and remove the bypass transport and
clear jams in the operator training that is provided by Xerox
following installation of the bypass transport.
In addition, you must know how to prepare the third-party
finishing device to process printed output. Obtain this information
from your third-party supplier.
Installation Planning Guide