Table of Contents
Advertisement
Steps
1. Place the heat sink on the system board and align the captive screws on the heat sink with the screw holes on the system
board.
2. Tighten the four (M2x3) screws to secure the heat sink to the system board.
Next steps
1. Install the
base
cover.
2. Exit
service
mode.
3. Install the
SD
card.
4. Follow the procedure in
Removing the heat sink - Discrete
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Enter
service
mode.
4. Remove the
base
cover.
About this task
The following images indicate the location of the discrete heat sink and provides a visual representation of the removal
procedure.
after working inside your
before working inside your
computer.
computer.
Removing and installing components
41
Advertisement
Table of Contents
