Table of Contents
Advertisement
5. Select the cable routing out of different options and route the cables to the dedicated
connectors inside UPS cabinet. Terminals are located under the circuit breaker and
are marked with +, - and a protecting earth designators.
6. Apply cable glands and/or plastic pass-through collars accordingly.
WARNING
Make sure all power sources are disconnected before next steps.
7. Connect the power cables and signal wires to the UPS. No signal wires are connected to
93E UPS.
8. Battery installation is to be done on-site by authorized and trained service personnel. Batteries are
to be installed on the shelves according to the following picture. Ensure you find a correct wiring
instruction included into the cabinet and follow it.
Figure 2 -4: Battery mounting on the shelves
P-164000427
Revision 2
SMALL and LARGE BATTERY CABINET
User's and Installation Guide
11
Advertisement
Table of Contents
