Ieee Cee Ceeeceeeeeeecesuseecessseeevsseeeeessecesseeee - Maytag MHN30PDBGW Installation Instructions Manual

PD Model Washer is coin payment ready and allows the use of
two different sizes of coins if a dual drop is installed. To set-up
the washer for coin payment, acquire a coin drop mechanism
with the appropriate coin sensors. Connect coin sensors to the
coin slot 1 and 2, respectively.
NOTE: For PD Models only.
1. Take the 2 foam pad strips from bag.
2. Remove tape from the back of adhesive pads.
3. Install the pads on the left and right inside walls of the coin
vault, leaving about 6 mm (1/4") to 13 mm (1/2") of space near
the front edge of the vault to allow room for the coin box to
lock into position.
A. Foam pad strips
10
1. Check the electrical requirements. Be sure that you have
the correct electrical supply and the recommended earthing
method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
. Check that you have all of your tools.
. Dispose of/recycle all packaging materials.
. Check that the water taps are on.
. Check for leaks around taps and inlet hoses.
°
Electric Shock Hazard
Plug into an earthed socket outlet.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electric shock.
7. Plug into an earthed socket outlet.
8. To test and to clean your washer, measure 1/2 the detergent
manufacturer's recommended amount for a medium-size load.
Pour the detergent into the detergent dispenser. Select any
cycle and allow the washer to complete one whole cycle.