Calibration - Xerox DocuColor 5750 Administrator's Manual

2
2-39 Color Setup options

Calibration

The Calibration menu lets you calibrate the copier from the copier glass using
AutoCal ™ (automatic calibration). The Calibration menu also lets you remove the
current calibration. When the DocuColor is calibrated, a color correction curve is
applied to every color document that is processed for printing.
Calibration is based on a set of density measurements and a series of target density
values for specific color patches. Calibration compensates for the difference between
measured values and target values.
Normally you create a calibration by specifying a standard target to use with measure-
ments that you took or measurements that you previously stored on the DocuColor.
You can also specify an alternative target to be used with the current measurements.
You don't need new measurements to calibrate with an alternative target. When you
choose Apply/Overwrite Calibration
latest measurements on the color server.
T
O PREPARE FOR CALIBRATION
1. If this is the first time you are setting up the DocuColor, complete Server Setup, Net-
work Setup, Printer Setup, PS Setup, and Color Setup, and Save Changes before you
perform a calibration.
2. When the DocuColor displays the Idle screen, press the Menu button on the Control
Panel to go to the Functions menu.
3. Press the down arrow to view the second screen of the Functions menu.
4. In the second screen, press the button to choose Reboot Server.
5. At the startup message, press any button.
6. Choose Run Setup to access all Setup menus.
7. Scroll to the second screen of the main Setup menu to choose Calibration.
PS Setup
Color Setup
Job Log Setup
Calibration
Setup
, the currently specified target will be used with the
: