Table of Contents
Advertisement
Safety Guidelines and Warnings
Danger
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams
or view directly with optical instruments. Statement 1051
Danger
Do not locate the antenna near overhead power lines or other electric light or power circuits, or where
it can come into contact with such circuits. When installing the antenna, take extreme care not to come
into contact with such circuits, because they may cause serious injury or death. For proper installation
and grounding of the antenna, please refer to national and local codes (for example, U.S.:NFPA 70,
National Electrical Code, Article 810, Canada: Canadian Electrical Code, Section 54). Statement 1052
Danger
Before connecting or disconnecting a power cord, you must remove power from the power cord using a
suitable service disconnect.
Danger
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Danger
All installation methods for mounting an AP on any wall surface is subject to the acceptance of local jurisdiction.
Danger
This product relies on the building s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than 20A. Statement 1005
Danger
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Danger
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a
minimum of 12 inches (30 cm) or more from the body of all persons. Statement 332
Danger
This equipment is suitable for use in environment air spaces (plenums) in accordance with Section
300.22 (C) of the National Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Canadian
Electrical Code, Part 1, CSA C22.2. External power supply, power adapter and/or power injector, if
provided, are not suitable for installation in air spaces. Statement 440
•
FCC Safety Compliance Statement, on page 92
•
Safety Precautions, on page 92
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
91
Advertisement
Table of Contents
