Table of Contents
Advertisement
Installation Overview
Table 7: Materials for Mounting AP to a Wall with AIR-MNT-ART1= Kit
Materials Needed
Ground lug and screws (provided with the access point)
Pivoting mount kit and hardware
(8) M6 x 12-mm Hex-head Bolts
Adapter bracket for option horizontal mount
Two stainless steel band clamps (adjustable 2 to 5 inch (51 to 127 mm)
Crimping tool for ground lug, Panduit CT-720 with CD-720-1 die
Four wall mounting screws (6 mm max)
#6 AWG ground wire
Shielded outdoor-rated Ethernet (CAT5e or better) cable
Grounding block
Grounding rod
13-mm box-end wrench or socket set
10-mm box-end wrench
Caution
The mounting surface, attaching screws, and optional wall anchors to support a 50 lb (22.7 kg) static weight.
Procedure
Step 1
Disassemble the pivot kit, if not already disassembled.
Step 2
Use the mounting bracket's wall-plate end as a template to mark four screw hole locations on the mounting
surface. See
locations (screw holes of maximum 6 mm). See
page 50
Step 3
Use four screws and, if required, wall anchors to attach the mounting bracket's wall-plate end to the mounting
surface. These screws and anchors are to be sourced independently.
Note
Step 4
Align the AP-plate end of the bracket with the screw holes in the AP's back.
Figure 58: Pivoting Wall Mounting Bracket , on page 49
for the dimensions of the pivoting mounting bracket.
• You can use an exterior-grade plywood backboard to mount the AP to stucco, cement, or
drywall.
• The mounting surface, attaching screws, and wall anchors must support a 50-lb (22.7 kg) static
weight. It is important to use proper anchoring for the mount surface to support the static load.
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
Articulating Mount for the AP to a Wall or Ceiling
Supplied in the
Kit?
Yes
Yes
Yes
Yes
Yes
No
No
No
No
No
No
No
No
for the mounting bracket screw hole
Figure 59: Pivoting Wall Mounting Bracket Dimensions, on
51
Advertisement
Table of Contents
